Institute of Microelectronics, Tsinghua University

---

Abstract—The IP security protocol (IPSec) is an important and widely used security protocol in the IP layer. But the implementation of the IPSec is a computing intensive work which greatly limits the performance of the high speed network. In this paper, a high performance IPSec accelerator used in a 10Gbps in-line network security processor (NSP) is presented. The design integrates the protocol processing and the cryptographic processing; the transport/tunnel mode of the AH, ESP security protocols and the AES, HMAC-SHA-1 cryptographic algorithms are realized by hardware. An efficient partial crossbar data transfer skeleton with iSLIP scheduling algorithm is adopted to realize the maximum utilization of the computation resources in the accelerator. The number of AH, ESP, AES, HMAC-SHA-1 cores in the design can be configured to meet the different applications. By simulation, with 8 protocol IP-cores and 24 crypto IP-cores connected to the crossbar in the IPSec accelerator, the design gives a peak throughput for the AH protocol transport mode of 11.28Gbps at the average of 512 bytes packet length under a clock rate of 300MHz. The hardware verification is implemented on a Virtex-5 XC5VSX95T based FPGA board. Low power design methods are also used in the design to reduce the power dissipation.

Index Terms—IPSec, network security processor, 10Gbps Ethernet, cryptographic algorithm, crossbar switch

[PDF]

Cite: Yun Niu, Liji Wu, and Xiangmin Zhang, " An IPSec Accelerator Design for a 10Gbps In- Line Security Network Processor," Journal of Computers vol. 8, no. 2, pp. 319-325, 2013.